蛇形磁路多片式磁流变液阻尼器设计
DOI:
作者:
作者单位:

1.东南大学仪器科学与工程学院 远程测控技术江苏省重点实验室南京210096;2.中国航天员科研训练中心人因工程国家重点实验室北京100094

作者简介:

通讯作者:

中图分类号:

TH703TP24

基金项目:

江苏省科技支撑项目(BE2014132)、国家自然科学基金(91648206)、国防基础科研计划(B1720132001)项目资助


Design of multidisc MRF damper with serpentine flux path
Author:
Affiliation:

1. Remote Measurement and Control Key Laboratory of Jiangsu Province,School of Instrument Science& Engineering,Southeast University,Nanjing 210096, China; 2. National Key Laboratory of Human Factors Engineering, China Astronaut Research and Training Center, Beijing 100094, China

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    提出了一种大输出阻尼力矩,低初始阻尼力的小体积多片式磁流变液阻尼器的设计方法。阻尼器内部的导磁元件、隔磁元件和间隙中磁流变液构成闭合的蛇形磁路。针对漏液的问题采用铁磁密封的设计思想,显著减小了转轴处的摩擦力。基于Bingham塑性模型分析了磁流变液的力学特性,导出了阻尼器的力矩模型,采用ANSYS Maxwell软件对阻尼器进行了有限元分析,验证了磁路的准确性,并在原始设计的基础上对阻尼器的结构进行了优化,研制出了一种小体积磁流变液阻尼器。在自主搭建的实验平台上进行力矩测量实验和响应时间测量实验,实验结果验证了该阻尼器具有大输出力矩,低初始阻尼力和低响应时间的特点。阻尼器的直径为33.6 mm,高度为21.6 mm,重约200 g,当输入电流为1.2 A时,产生的力矩为350 N·mm,达到了操作者抓取虚拟物体所需的力矩。

    Abstract:

    The design method of a new type multidisc MRF damper with large output damper torque, low initial damper force is introduced. The magnetic elements, nonmagnetic elements and magneto rheological fluid (MRF) in the gap constitute a closed serpentine flux path inside the damper. Aiming at the leakage problem, the design idea of ferrofluidic sealing is adopted, which significantly reduces the friction force at the rotating shaft. Based on the Bingham plastic model, the paper analyzes the mechanical characteristics of MRF, and derives the damper torque model. The ANSYS Maxwell software is used to conduct the finite element analysis of the damper, which verifies the accuracy of the flux path, and then the structure of the damper is improved on the basis of the original design. Finally, a small volume MRF damper was developed. An experiment platform was built by our own, on which torque measurement experiment and response time measurement experiment were carried out; the experiment results verify that the damper has the characteristics of large output torque, low initial damping force and low response time. The diameter of the damper is 33.6 mm, its height is 21.6 mm, and the weight is about 200 g; when the input current is 1.2 A, the output torque is about 350 N·mm, which reaches the required torque for the operator to grasp virtual objects.

    参考文献
    相似文献
    引证文献
引用本文

高瞻,宋爱国,秦欢欢,陈大鹏,刘玉庆,姜国华.蛇形磁路多片式磁流变液阻尼器设计[J].仪器仪表学报,2017,38(4):821-829

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2017-07-19
  • 出版日期: